REMOVAL
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. REMOVE BLOWER MOTOR WITH FAN SUB-ASSEMBLY |
w/o PTC Heater:

Disconnect the 2 connectors and detach the 2 clamps and wire harness.
w/ PTC Heater:
Disconnect the 4 connectors and detach the 3 clamps and wire harness.Text in Illustration *A
w/o PTC Heater
*B
w/ PTC Heater
Remove the 3 screws and blower motor with fan sub-assembly.

