2014 Hilux · Service Manual TRANSMISSION

P0818 Driveline Disconnect Switch Input Circuit

Diagnostic trouble codes · Vehicles built from Jun 2011

DESCRIPTION

The TCM detects the signal from the transfer neutral position switch.
This DTC indicates that the transfer neutral position switch remains on.
DTC Code
DTC Detection Condition
Trouble Area
P0818
Transfer neutral position switch remains on while the vehicle is being driver under the following conditions for 30 sec. (2 trip detection logic):
  1. Vehicle speed is 25 km/h (16 mph) or more.
  2. Transfer shift lever is on H.
  1. Short in transfer neutral position switch circuit
  2. No. 2 transfer indicator switch
  3. TCM

MONITOR DESCRIPTION

The TCM detects whether or not the transfer shift lever is in neutral by monitoring the signal from the transfer neutral position switch.
If the TCM detects that the transfer shift lever is in neutral under all of the following conditions, the TCM will conclude that there is a malfunction of the transfer neutral position switch:
  1. Transfer neutral position switch indicates that the transfer shift lever is in neutral.
  2. Transfer shift lever is in the H position.
  3. The vehicle is traveling at 25 km/h (16 mph) or more.
  4. The transfer neutral position switch has been on for more than 30 seconds.
Then the TCM will illuminate the MIL and store the DTC.

WIRING DIAGRAM

C154998E26

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - BODY GROUND)
C193097E07
  1. Disconnect the T5 transfer indicator switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Transfer Connection
    Condition
    Specified Condition
    T5-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
C193150E04
  1. Remove the transfer indicator switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω



NG
REPLACE NO. 2 TRANSFER INDICATOR SWITCH (TRANSFER NEUTRAL POSITION SWITCH)
OK


3. CHECK HARNESS AND CONNECTOR (NO. 2 TRANSFER INDICATOR SWITCH - TCM)

  1. C193088E07
    Disconnect the T5 transfer indicator switch connector.

  1. Disconnect the T37 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T5-1 - T37-16 (TFN)
    Always
    Below 1 Ω
    T37-16 (TFN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM


← P0781 1-2 Shift (1-2 Shift Valve) (from Aug 2012)P0894 Transmission Component Slipping (+ P2714) (Jun 2011 – Jul 2012) →