2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 AIR CLEANER HOSE
  1. Disconnect the IAT sensor connector.

  1. Detach the clamp of the IAT sensor harness.

  1. Loosen the 2 clamps from the air cleaner hose.

  1. Remove the air cleaner hose.


3. REMOVE INTAKE PIPE ASSEMBLY

  1. A114290
    Remove the 2 bolts and loosen the hose clamp.


4. REMOVE INTAKE FLANGE

  1. A114283
    Remove the bolt and clamp of the heater hose.

  1. A114284
    Disconnect the manifold absolute pressure sensor connector.

  1. A114285
    Loosen the clamp and then disconnect the ventilation hose.

  1. Remove the 3 nuts, intake flange and gasket.


5. REMOVE VENTURI ASSEMBLY

  1. A111052E02
    Disconnect the throttle open switch connector.

  1. A111053E02
    Disconnect the throttle control motor connector.

  1. Remove the venturi and gasket.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →