2014 Hilux · Service Manual ENGINE

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use these procedures to troubleshoot the ECD system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.CONNECT INTELLIGENT TESTER TO DLC3*

        HINT:
        If the display indicates a communication fault with the tester, inspect the DLC3.

      NEXT

      4.CHECK DTC AND FREEZE FRAME DATA*

        HINT:
        Record or print DTCs and freeze frame data if necessary.

      NEXT

      5.CLEAR DTC AND FREEZE FRAME DATA*
        NEXT

        6.VISUAL INSPECTION
          NEXT

          7.SET CHECK MODE DIAGNOSIS*
          1. Refer to the check mode procedure (Click here).

          NEXT

          8.CONFIRM PROBLEM SYMPTOMS

            HINT:
            If the engine does not start, first perform the "CHECK DTC" procedures and "BASIC INSPECTION" procedures below.

            Result:
            Result
            Proceed to
            Malfunction occurs
            A
            Malfunction does not occur
            B


          B.
          A

          9.CHECK DTC

            Result:
            Result
            Proceed to
            Malfunction code
            A
            No malfunction code
            B


          B.
          A

          10.REFER TO DTC CHART*
          1. Refer to the diagnostic trouble code chart (Click here).

          NEXT

          11.BASIC INSPECTION

            Result:
            Result
            Proceed to
            Malfunctioning parts not confirmed
            A
            Malfunctioning parts confirmed
            B


          B.
          A

          12.REFER TO PROBLEM SYMPTOMS TABLE

            HINT:
            If the customer's problem description is applicable to one of the following problems, refer to the troubleshooting on the pages shown below:
            Symptom
            Condition
            See page
            Engine difficult to or stalling
            1. Engine difficult to start with cold engine
            2. Engine difficult to start with warm engine
            3. Engine stalls soon after starting
            4. Any condition other than those listed above
            Click here
            Black smoke emitted
            1. When idling
            2. When driving
            Click here
            Rough idling or excessive engine vibration
            1. Abnormal initial idling
            2. High engine idling speed
            3. Low engine idling speed
            Click here
            Lack of power or hesitation
            1. Hunting with cold engine
            2. Hunting with warm engine
            3. Surging with cold engine
            4. Surging with warm engine
            5. Poor acceleration
            6. Poor driveability
            Click here
            Engine knocking or rattling
            1. When idling
            2. When driving
            Click here

            Result:
            Result
            Proceed to
            Malfunctioning circuit confirmed
            A
            Malfunctioning parts confirmed
            B


          B.
          A

          13.CHECK ECM POWER SOURCE CIRCUIT
            NEXT

            14.CONDUCT CIRCUIT INSPECTION

              Result:
              Result
              Proceed to
              Malfunction not confirmed
              A
              Malfunction confirmed
              B


            B.
            A

            15.CHECK FOR INTERMITTENT PROBLEMS
              NEXT

              16.PARTS INSPECTION
                NEXT

                17.IDENTIFY PROBLEM
                  NEXT

                  18.ADJUST AND/OR REPAIR
                    NEXT

                    19.CONFIRMATION TEST
                      NEXT

                      ← SYSTEM DESCRIPTION (from Jun 2011)HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2012 – Jul 2013) →