HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use these procedures to troubleshoot the ECD system.
- *: Use the intelligent tester.
- Use these procedures to troubleshoot the ECD system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.CONNECT INTELLIGENT TESTER TO DLC3* |
- HINT:
- If the display indicates a communication fault with the tester, inspect the DLC3.
| |||||
| 4.CHECK DTC AND FREEZE FRAME DATA* |
- HINT:
- Record or print DTCs and freeze frame data if necessary.
| |||||
| 5.CLEAR DTC AND FREEZE FRAME DATA* |
| |||||
| 6.VISUAL INSPECTION |
| |||||
| 7.SET CHECK MODE DIAGNOSIS* |
Refer to the check mode procedure (Click here)
| |||||
| 8.CONFIRM PROBLEM SYMPTOMS |
- HINT:
- If the engine does not start, first perform the "CHECK DTC" procedures and "BASIC INSPECTION" procedures below.
- Result:
Result
Proceed to
Malfunction occurs
A
Malfunction does not occur
B
|
|||||
| |||||
| 9.CHECK DTC |
- Result:
Result
Proceed to
Malfunction code
A
No malfunction code
B
|
|||||
| |||||
| 10.REFER TO DTC CHART* |
Refer to the diagnostic trouble code chart (Click here)
| |||||
| 11.CONDUCT BASIC INSPECTION |
- Result:
Result
Proceed to
Malfunctioning parts not confirmed
A
Malfunctioning parts confirmed
B
|
|||||
| |||||
| 12.REFER TO PROBLEM SYMPTOMS TABLE |
- HINT:
- If the customer's problem description is applicable to one of the following problems, refer to the troubleshooting on the pages shown below:
Symptom
Condition
See page
Engine difficult to or stalling
- Engine difficult to start with cold engine
- Engine difficult to start with warm engine
- Engine stalls soon after starting
- Any condition other than those listed above
Click here
Black smoke emitted
- When idling
- When driving
Click here
Rough idling or excessive engine vibration
- Abnormal initial idling
- High engine idling speed
- Low engine idling speed
Click here
Lack of power or hesitation
- Hunting with cold engine
- Hunting with warm engine
- Surging with cold engine
- Surging with warm engine
- Poor acceleration
- Poor driveability
Click here
Engine knocking or rattling
- When idling
- When driving
Click here
- Engine difficult to start with cold engine
- Result:
Result
Proceed to
Malfunctioning circuit confirmed
A
Malfunctioning parts confirmed
B
|
|||||
| |||||
| 13.CHECK ECM POWER SOURCE CIRCUIT |
| |||||
| 14.CONDUCT CIRCUIT INSPECTION |
- Result:
Result
Proceed to
Malfunctioning circuit confirmed
A
Malfunctioning parts confirmed
B
|
|||||
| |||||
| 15.CHECK FOR INTERMITTENT PROBLEMS |
| |||||
| 16.CONDUCT PARTS INSPECTION |
| |||||
| 17.IDENTIFY PROBLEM |
| |||||
| 18.ADJUST AND/OR REPAIR |
| |||||
| 19.CONDUCT CONFIRMATION TEST |
| |||||