DTC CHECK / CLEAR
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
- NOTICE:
- When the diagnosis system is changed from the normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are erased. Before changing modes, always check and make a note of DTCs and freeze frame data.
- HINT:
- DTCs which are stored in the ECM can be displayed on the intelligent tester. The intelligent tester can display current and pending DTCs.
- Same DTCs are not set if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.
- DTCs which are stored in the ECM can be displayed on the intelligent tester. The intelligent tester can display current and pending DTCs.
| CHECK DTC (Using Intelligent Tester) |
Connect the intelligent tester to the DLC3.

Turn the ignition switch ON.
Turn the tester ON.
Enter the following menus: Powertrain / Engine / DTC.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC (Using Intelligent Tester) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Enter the following menus: Powertrain / Engine / DTC / Clear.
Press the YES button.
| CLEAR DTC (Without using Intelligent Tester) |
Perform either one of the following operations.
Disconnect the negative battery cable for more than 1 minute.
Remove the EFI fuses from the engine room junction block (located inside the engine compartment) for more than 1 minute.
