2014 Hilux · Service Manual ENGINE

INITIALIZATION

Troubleshooting · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012

HINT:
After replacing the supply pump and/or ECM:

  1. If the engine is defective or stalls immediately after startup, the ECM's learned values must be initialized. The engine can be initialized through the intelligent tester or by short circuit DLC3 terminals.
  2. If the engine starts normally, initialization is not necessary. Perform procedure "A" and procedure "B" only.

SUPPLY PUMP INITIALIZATION PROCEDURE

  1. A141744E01
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

    NOTICE:
    Do not start the engine.

  3. Turn the intelligent tester ON.

  4. Enter the following menus: Powertrain / Engine / Utility / Supply Pump Initialization.

  5. Press Next.

  6. A141745E01
    Press Next.

  7. A141746E01
    Press Exit.

  8. Start the engine to check if the initialization is complete. If the engine cannot be started, repeat the initialization procedures from the beginning.

  9. Idle the engine for at least 1 minute under the following conditions (Procedure "A"):

    1. The water temperature is 60°C (140°F) or more.
    2. The fuel temperature is 20°C (68°F) or more.

    NOTICE:
    1. Do not the race engine immediately after starting the engine.
    2. After idling the engine, racing the engine is acceptable.

      HINT:
      1. The water temperature can be estimated by touching the outlet hose.
      2. The fuel temperature can be estimated by using the ambient temperature as a substitute.
      3. If the water and fuel temperature is difficult to estimate, use the intelligent tester and enter the following menus: Powertrain / Engine / Data List / Coolant Temp.

  10. Initialization is complete (Procedure "B").

← REGISTRATION (from Aug 2014)INITIALIZATION (from Aug 2012) →