P0168 Fuel Temperature Too High
Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
Refer to DTC P0180 on page Click here.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0168 |
If fuel temperature is between 35°C (95°F) and 60°C (140°F) at engine start, and conditions (a) and (b) are met: (1 trip detection logic)
|
Fuel temperature sensor |
| P0168 |
If fuel temperature was more than 60°C (140°F) at engine start, and conditions (a) and (b) are met: (1 trip detection logic)
|
Fuel temperature sensor |
INSPECTION PROCEDURE
- HINT:
- If DTCs P0180, P0182 or P0183 is set simultaneously with P0168, the fuel temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, and other data from the time the malfunction occurred.
- If DTCs P0180, P0182 or P0183 is set simultaneously with P0168, the fuel temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.
| 1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P01683) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
- Result:
Display (DTC Output)
Proceed to
P0168
A
P0168 and other DTCs
B
- HINT:
- If any DTCs other than P0168 are output, perform the troubleshooting for those codes first.
|
|
||||
| A | ||
| ||
