REMOVAL
Removal / installation · Vehicles built from Jun 2011
- CAUTION:
- Wear protective gloves when removing the exhaust pipe assembly.
- The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
- Confirm that the exhaust pipe assembly has cooled down before removing it.
- Wear protective gloves when removing the exhaust pipe assembly.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE TAILPIPE ASSEMBLY |
Remove the 2 bolts and 2 nuts.
Disconnect the tailpipe from the center pipe and remove the gasket.
Remove the tailpipe from the pipe support.
| 3. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
Remove the 2 bolts and 2 nuts.
Disconnect the center pipe from the front pipe and remove the gasket.
Remove the center pipe from the 3 pipe supports.
| 4. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 1) |
Disconnect the sensor connector.

Detach the 3 wire clamps.
Using SST, remove the sensor.

- SST
- 09224-00010
| 5. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Remove the 2 bolts and 2 compression springs.
Disconnect the front pipe from the exhaust manifold and remove the gasket.
Remove the front pipe from the pipe support.
