REMOVAL
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. REMOVE INTAKE AIR CONNECTOR AND AIR CLEANER ASSEMBLY |
![]() ![]() |
Disconnect the vacuum hose.
Disconnect the No. 2 ventilation hose.
Disconnect the MAF meter connector and wire harness clamps.
Loosen the hose clamp and remove the 4 bolts, air cleaner and intake air connector assembly.
| 3. REMOVE DRIVE BELT |
Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.

- NOTICE:
- When removing the drive belt, do not use the idle pulley's bolt.
- HINT:
- After removing the drive belt, move the tensioner upward to the maximum amount.
| 4. REMOVE GENERATOR ASSEMBLY |
Remove the nut, bolt and generator wire.

Disconnect the generator connector.
Remove the 2 bolts and generator.

