2014 Hilux · Service Manual STEERING

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. PRECAUTION
(Click here)

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

4. REMOVE STEERING PAD ASSEMBLY (for 3 Spoke)

  1. C238862
    Remove the screw.

  1. C238863
    Detach the 3 pins and remove the steering pad.

  1. Disconnect the horn wire.


5. REMOVE STEERING PAD ASSEMBLY (for 4 Spoke)
(Click here)

6. REMOVE STEERING PAD SWITCH (for 4 Spoke with Steering Pad Switch)
(Click here)

7. REMOVE NO. 2 STEERING WHEEL ORNAMENT (for 4 Spoke without Steering Pad Switch)

  1. C238010E01
    Remove the screw.

  1. Detach the 2 pins and remove the steering wheel ornament.

    Text in Illustration 
    *1
    Pin


8. REMOVE NO. 1 STEERING WHEEL ORNAMENT (for 4 Spoke without Steering Pad Switch)

  1. C238012E01
    Remove the screw.

  1. Detach the 2 pins and remove the steering wheel ornament.

    Text in Illustration 
    *1
    Pin


9. REMOVE STEERING WHEEL ASSEMBLY
  1. Remove the steering wheel assembly set nut.

  1. C238699E03
    Put matchmarks on the steering wheel assembly and steering main shaft.

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.


10. REMOVE STEERING COLUMN LOWER COVER

G039357E01
  1. Remove the 3 screws and cover lower.


11. REMOVE STEERING COLUMN UPPER COVER

12. REMOVE INSTRUMENT LOWER PANEL FINISH PANEL SUB-ASSEMBLY

B278242
  1. Detach the 2 claws, 3 clips and 3 guides and remove the lower instrument panel finish panel.


13. REMOVE SPIRAL CABLE SUB-ASSEMBLY

B110259E01
  1. Disconnect the connectors from the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Detach the 3 claws and remove the spiral cable.


14. REMOVE WIPER AND WASHER SWITCH ASSEMBLY

  1. E225945
    Disconnect the connectors.

  1. Detach the claw and remove the windshield wiper switch.

    NOTICE:
    Do not push the claw with excessive force as damage may occur.


15. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY

  1. B087887
    Disconnect the connector.

  1. B113202
    Using needle-nose pliers, remove the band clamp as shown in the illustration.

  1. B085631
    Using a screwdriver, detach the claws and remove the switch.

    HINT:
    Tape the screwdriver tip before use.


16. DISCONNECT STEERING SLIDING YOKE

G035017E02
  1. Loose the bolt labeled A.

  1. Make matchmarks on the steering yoke and steering intermediate shaft.

  1. Remove the bolt labeled B.


17. DISCONNECT CONNECTOR
  1. Disconnect the connectors.


18. REMOVE STEERING COLUMN HOLE COVER SUB-ASSEMBLY

  1. G039074E02
    Remove the 3 bolts and cover.


19. REMOVE STEERING COLUMN ASSEMBLY
  1. Remove the 3 bolts and pull out the steering column together with the steering sliding with coupling yoke.

← COMPONENTS (from Jun 2011)DISASSEMBLY (from Jun 2011) →