INSTALLATION
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- NOTICE:
- When working with seal packing, perform the following:
- Using a razor blade and gasket scraper, remove all old seal packing from the gasket surfaces.
- Clean all components thoroughly to remove all foreign matter.
- Clean both sealing surfaces with a non-residue solvent.
- Apply seal packing in a continuous line approximately 2 to 3 mm (0.0788 to 0.118 in.) in diameter on the sealing surface.
- Reassemble parts within 10 minutes of applying seal packing. Failing to do so will require the seal packing to be removed and reapplied.
| 1.
INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
 |
- Install the valve body and align the groove of the manual valve with the pin of the manual valve lever.
- Install the 20 bolts.
-
Torque:
- 11 N*m{
110 kgf*cm
, 8 ft.*lbf
}
- HINT:
- Each bolt length is indicated below.
- 23 mm (0.91 in.) for A
- 28 mm (1.10 in.) for B
- 36 mm (1.42 in.) for C
| 2.
CONNECT TRANSMISSION WIRE
|
 |
Connect the 4 connectors to the 4 shift solenoid valves.
| 3.
INSTALL VALVE BODY OIL STRAINER ASSEMBLY
|
 |
Install 3 new gaskets.
- Install the oil strainer with the 4 bolts.
-
Torque:
- 11 N*m{
110 kgf*cm
, 8 ft.*lbf
}
- HINT:
- Bolt length:
- 14 mm (0.55 in.) for A
- 20 mm (0.79 in.) for B
- 23 mm (0.91 in.) for C
| 4.
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
|
 |
- HINT:
- Remove any packing material and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.
Install the 3 magnets to the locations indicated in the illustration.
- Apply seal packing to the oil pan as shown in the illustration.
- Seal packing:
- Toyota Genuine Seal Packing 1281,
Three Bond 1281 or equivalent
- Seal width:
- 2 to 3 mm (0.0787 to 0.118 in.)
Install the oil pan with the 19 bolts.
-
Torque:
- 7.4 N*m{
75 kgf*cm
, 65 in.*lbf
}
| 5.
INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY
|
 |
Coat a new O-ring with ATF, and install it to the oil filler tube.
Install the oil filler tube with the 2 bolts.
-
Torque:
- 12 N*m{
122 kgf*cm
, 9 ft.*lbf
}
Install the oil dipstick.
| 6.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.
| 7.
PERFORM INITIALIZATION |
 |
Perform initialization (Click here).
| 8.
ADD AUTOMATIC TRANSMISSION FLUID |
 |
- Fluid type:
- Toyota Genuine ATF Type T-IV
| 9.
INSPECT AUTOMATIC TRANSMISSION FLUID |
 |
Inspect the automatic transmission fluid (Click here).