INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT FRONT OIL PUMP BODY |
![]() ![]() |
Using a dial indicator, measure the inside diameter of the oil pump body bush.
- Maximum inside diameter:
- 38.19 mm (1.5035 in.)
| INSPECT STATOR SHAFT ASSEMBLY |
![]() ![]() |
Using a dial indicator, measure the inside diameter of the stator shaft bush.
- Maximum inside diameter:
Front side
Rear side
21.58 mm (0.8496 in.)
27.08 mm (1.0661 in.)
| INSPECT CLEARANCE OF FRONT OIL PUMP BODY |
![]() ![]() |
Push the driven gear to one side of the body.
Using a feeler gauge, measure the clearance.
- Standard body clearance:
- 0.07 to 0.15 mm (0.0028 to 0.0059 in.)
- Maximum body clearance:
- 0.2 mm (0.0079 in.)
Using a feeler gauge, measure the tip clearance between the driven gear teeth and drive gear teeth.

- Standard tip clearance:
- 0.004 to 0.248 mm (0.0002 to 0.0098 in.)
- Maximum tip clearance:
- 0.3 mm (0.012 in.)
Using a steel straightedge and feeler gauge, measure the side clearance of both gears.

- Standard side clearance:
- 0.02 to 0.05 mm (0.0008 to 0.0020 in.)
- Maximum side clearance:
- 0.1 mm (0.004 in.)
- HINT:
- There are 5 different thicknesses for drive and driven gears.
Drive and driven gear thickness: Mark
Thickness
M
11.690 to 11.699 mm (0.4602 to 0.4606 in.)
N
11.700 to 11.709 mm (0.4606 to 0.4610 in.)
P
11.710 to 11.720 mm (0.4610 to 0.4614 in.)
R
11.721 to 11.730 mm (0.4615 to 0.4618 in.)
S
11.731 to 11.740 mm (0.4618 to 0.4622 in.)
| INSPECT OIL PUMP DRIVE GEAR ROTATION |
![]() ![]() |
Make sure the drive gear rotates smoothly.
Remove the oil pump from the torque converter.




