2014 Hilux · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL 2ND COAST BRAKE PISTON ROD

AT07705E01
  1. Check the piston rod length.

    HINT:
    There are 2 different standard lengths for the piston rod.

    Piston rod length:
    Groove Number
    Length
    0
    78.4 mm (3.087 in.)
    1
    79.9 mm (3.146 in.)

    If the length is not as specified, replace the rod with a new one even if the brake band works normally.

  1. D001299E03
    Install the washer plate, compression spring and piston to the piston rod.

  1. AT05260E01
    Firmly hold down the piston, then compress the compression spring.

  1. Install the E-ring.


2. INSTALL 2ND COAST BRAKE PISTON OIL SEAL RING

G037154E01
  1. Coat the oil seal ring with ATF.

  1. Spread the ends of the ring to install the oil seal ring to the piston groove. Then squeeze its ends together.

    NOTICE:
    Do not expand the ring ends excessively.

← INSPECTION (from Jun 2011)COMPONENTS (from Jun 2011) →