DISASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE |
![]() ![]() |
Place the overdrive support assembly onto the direct clutch assembly.
Apply compressed air (392 kPa (4 kgf/cm2, 57 psi)) into the oil passage, and check that the overdrive brake piston moves smoothly.

| 2. REMOVE OVERDRIVE BRAKE RETURN SPRING |
![]() ![]() |
Place SST on the retainer spring, and compress the return spring with a press.
- SST
- 09350-30020
(09350-07030)
Using a screwdriver, pry out the snap ring.
Remove the brake return spring.
| 3. INSPECT OVERDRIVE BRAKE RETURN SPRING |
![]() ![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.
- Standard free length:
- 17.03 mm (0.671 in.)
| 4. REMOVE OVERDRIVE BRAKE PISTON |
![]() ![]() |
Place the overdrive support onto the direct clutch assembly.
Hold the overdrive brake piston so that it does not slant, and apply compressed air (392 kPa (4 kgf/cm2, 57 psi)) into the passage to remove the overdrive brake piston.
Remove the overdrive brake piston.
Remove the 2 O-rings.

| 5. REMOVE OVERDRIVE CLUTCH DRUM OIL SEAL RING |
![]() ![]() |
Remove the 2 oil seal rings.
Remove the clutch drum thrust washer from the overdrive support.

| 6. INSPECT OVERDRIVE BRAKE CLUTCH DISC |
![]() ![]() |
Replace all discs if one of the following problems is present: 1) a disc, plate or flange is worn or burnt, 2) the lining of a disc is peeled off or discolored, or 3) grooves or printed numbers have even a little bit of damage.
- NOTICE:
- Before assembling new discs, soak them in ATF for at least 15 minutes.






