2014 Hilux · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE

AT08451E01
  1. Place the overdrive support assembly onto the direct clutch assembly.

  1. AT08149E01
    Apply compressed air (392 kPa (4 kgf/cm2, 57 psi)) into the oil passage, and check that the overdrive brake piston moves smoothly.


2. REMOVE OVERDRIVE BRAKE RETURN SPRING

AT08444E01
  1. Place SST on the retainer spring, and compress the return spring with a press.

    SST
    09350-30020   (09350-07030)

  1. Using a screwdriver, pry out the snap ring.

  1. Remove the brake return spring.


3. INSPECT OVERDRIVE BRAKE RETURN SPRING

D001246E01
  1. Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    17.03 mm (0.671 in.)

    If the length is not as specified, replace the spring.


4. REMOVE OVERDRIVE BRAKE PISTON

D001432E01
  1. Place the overdrive support onto the direct clutch assembly.

  1. Hold the overdrive brake piston so that it does not slant, and apply compressed air (392 kPa (4 kgf/cm2, 57 psi)) into the passage to remove the overdrive brake piston.

  1. Remove the overdrive brake piston.

  1. D001336E01
    Remove the 2 O-rings.


5. REMOVE OVERDRIVE CLUTCH DRUM OIL SEAL RING

AT08160E01
  1. Remove the 2 oil seal rings.

  1. AT08158E01
    Remove clutch drum thrust washer from overdrive support.


6. INSPECT OVERDRIVE BRAKE CLUTCH DISC

AT06454E01
  1. Replace all discs if one of the following problems is present: 1) a disc, plate or flange is worn or burnt, 2) the lining of a disc is peeled off or discolored, or 3) grooves or printed numbers have even a little bit of damage.

    NOTICE:
    Before assembling new discs, soak them in ATF for at least 15 minutes.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →