REASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1.
INSTALL 2ND BRAKE PISTON |
 |
Coat 2 new O-rings with ATF, and install them on the 2nd brake piston.
Being careful not to damage the O-rings, and press the 2nd brake piston into the 2nd brake drum with both hands.
| 2.
INSTALL 2ND BRAKE PISTON RETURN SPRING |
 |
Install the piston return spring.
Install the spring retainer.
- Place SST on the spring retainer, and compress the return spring with a press.
- SST
- 09350-30020
(09350-07040)
- NOTICE:
- Do not deform the spring sheet. Stop compressing when the spring sheet is lowered to 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove.
- Do not expand the snap ring excessively.
Using a snap ring expander, install the snap ring.
| 3.
INSPECT 2ND BRAKE PISTON
|
 |
Make sure the 2nd brake piston moves smoothly when applying and releasing low-pressure compressed air to the 2nd brake drum.
| 4.
INSTALL NO. 4 PLANETARY CARRIER THRUST WASHER |
 |
Coat the thrust washer with petroleum jelly, and install it.
- HINT:
- Make sure that the cutout portions of the thrust washer fit into the teeth of the spring retainer.