2014 Hilux · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE OUTPUT SHAFT

AT08197E01

2. REMOVE PLANETARY OUTPUT SHAFT OIL SEAL RING

AT08198E01

3. REMOVE REAR PLANETARY RING GEAR

AT08199E01

4. INSPECT NO. 2 ONE-WAY CLUTCH

AT08200E03
  1. Hold the planetary gear and turn the one-way clutch inner race. Check that the one-way clutch inner race can be turned freely counterclockwise and locks when turned clockwise.


5. REMOVE NO. 2 ONE-WAY CLUTCH

AT08191E01
  1. Remove the inner race from the planetary gear.

  1. AT08192E01
    Using a screwdriver, pry out the snap ring.

  1. AT08193E01
    Remove the one-way clutch with the retainers from the planetary gear.


6. REMOVE NO. 2 PLANETARY CARRIER THRUST WASHER

D028060E01

7. REMOVE NO. 1 PLANETARY CARRIER THRUST WASHER

D028061E01

8. REMOVE REAR PLANETARY FLANGE THRUST NEEDLE ROLLER BEARING

AT08437E01
  1. Remove the 2 races and bearing from the planetary ring gear.


9. REMOVE REAR PLANETARY RING GEAR FLANGE

AT08206E01
  1. Using a screwdriver, pry out the snap ring.

  1. AT08207E01
    Remove the ring gear flange.


10. INSPECT PLANETARY PINION GEAR THRUST CLEARANCE

AT04459E01
  1. Using a feeler gauge, measure the thrust clearance.

    Standard clearance:
    0.20 to 0.60 mm (0.0079 to 0.0236 in.)

    Maximum clearance:
    0.65 mm (0.0256 in.)

    If the clearance is greater than the maximum, replace the planetary gear.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →