INSTALLATION
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1.
INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
 |
Install the spring and check ball body.
Insert the pin of the manual valve into the hole of the manual valve lever.
- Install the transmission valve body with the 19 bolts.
-
Torque:
- 11 N*m{
112 kgf*cm
, 8 ft.*lbf
}
- HINT:
- Each bolt length is indicated below.
- 36 mm (1.42 in.) for bolt A
- 25 mm (0.984 in.) for bolt B
Install the detent spring and detent spring cover with the bolt.
-
Torque:
- 10 N*m{
102 kgf*cm
, 7 ft.*lbf
}
| 2.
CONNECT TRANSMISSION WIRE
|
 |
Connect the 7 connectors to the solenoid valves.
Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.
-
Torque:
- for bolt A:
- 10 N*m{
102 kgf*cm
, 7 ft.*lbf
}
- for bolt B:
- 11 N*m{
112 kgf*cm
, 8 ft.*lbf
}
- HINT:
- Each bolt length is indicated below.
- 12 mm (0.472 in.) for bolt A
- 36 mm (1.42 in.) for bolt B
| 3.
INSTALL VALVE BODY OIL STRAINER ASSEMBLY
|
 |
Coat a new O-ring with ATF and install it to the oil strainer.
-
Torque:
- 10 N*m{
102 kgf*cm
, 7 ft.*lbf
}
| 4.
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
|
 |
- HINT:
- Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.
Install a new gasket and the oil pan with the 20 bolts.
-
Torque:
- 7.0 N*m{
71 kgf*cm
, 62 in.*lbf
}
| 5.
INSTALL NO. 1 ENGINE MOUNTING INSULATOR REAR (for 1KD-FTV)
|
 |
Install the engine mounting insulator to the transmission with the 4 bolts.
-
Torque:
- 47 N*m{
479 kgf*cm
, 35 ft.*lbf
}
| 6.
INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY (for 1KD-FTV)
|
 |
Install the frame crossmember to the engine mounting insulator with the 4 set bolts.
-
Torque:
- 27 N*m{
275 kgf*cm
, 20 ft.*lbf
}
Connect the ends of the frame crossmember to the vehicle with the 4 bolts and 4 nuts.
-
Torque:
- 50 N*m{
510 kgf*cm
, 37 ft.*lbf
}
| 7.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.
| 8.
PERFORM INITIALIZATION |
 |
Perform initialization (Click here).
| 9.
ADD AUTOMATIC TRANSMISSION FLUID |
 |
Add automatic transmission fluid (Click here).