REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. DRAIN AUTOMATIC TRANSMISSION FLUID |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
- Torque:
- 20 N*m{ 204 kgf*cm , 15 ft.*lbf }
| 3. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY (for 1KD-FTV) |
![]() ![]() |
Remove the 4 bolts and engine mounting insulator rear from the automatic transmission.
| 4. REMOVE NO. 1 ENGINE MOUNTING INSULATOR REAR (for 1KD-FTV) |
![]() ![]() |
Remove the 4 bolts and engine mounting insulator rear from the automatic transmission.
| 5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY |
![]() ![]() |
- NOTICE:
- Some fluid will remain in the oil pan.
Remove the 20 bolts.
Examine the particles in the pan.

Remove all the magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the pan and on the magnets to determine the type of wear you will find in the transmission.
Steel (magnetic): bearing, gear and clutch plate wear
Brass (non-magnetic): bush wear
| 6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY |
![]() ![]() |
Remove the 4 bolts and oil strainer.
- NOTICE:
- Be careful as some fluid will come out of the oil strainer.
Remove the O-ring from the oil strainer.
| 7. DISCONNECT TRANSMISSION WIRE |
![]() ![]() |
Remove the 2 bolts and 2 temperature sensor clamps.
Disconnect the ATF temperature sensor.
Disconnect the 7 connectors from the solenoid valves.
| 8. REMOVE TRANSMISSION VALVE BODY ASSEMBLY |
Remove the bolt, detent spring cover and detent spring.
Remove the 19 bolts and valve body.

Remove the check ball body and spring.

- NOTICE:
- Do not drop the check ball body and spring.




