2014 Hilux · Service Manual TRANSMISSION

ADJUSTMENT

Removal / installation · Vehicles built from Jun 2011


1. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch to ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D, and moves in reverse after shifting to R.
    If the results are not as specified, inspect the park/ neutral position switch and check the shift lever.


2. ADJUST SHIFT LEVER POSITION
  1. Move the shift lever to N.

  1. G034515E02
    Remove the nut and disconnect the control cable.

  1. C236140E01
    Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.

  1. While holding the control shaft lever slightly toward the R position side, connect the cable with the nut.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

← DISASSEMBLY (from Jun 2011)REASSEMBLY (from Jun 2011) →