INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
![]() ![]() |
Using a dial indicator, measure the inside diameter of the oil pump body bushing.
- Maximum inside diameter:
- 38.188 mm (1.504 in.)
- If the inside diameter is greater than the maximum, replace the oil pump body.
| INSPECT STATOR SHAFT ASSEMBLY |
![]() ![]() |
Using a dial indicator, measure the inside diameter of the stator shaft bushing.
- Maximum inside diameter:
- Front side:
- 21.577 mm (0.850 in.)
- Rear side:
- 32.08 mm (1.263 in.)
- If the inside diameter is grater than the maximum, replace the stator shaft.
| INSPECT CLEARANCE OF OIL PUMP ASSEMBLY |
![]() ![]() |
Push the driven gear to one side of the body.
Using a feeler gauge, measure the clearance.
- Standard body clearance:
- 0.10 to 0.17 mm (0.00039 to 0.00067 in.)
- Maximum body clearance:
- 0.17 mm (0.0067 in.)
- If the body clearance is greater than the maximum, replace drive gear, the driven gear or pump body.
Using a feeler gauge, measure the clearance between the driven gear teeth and drive gear teeth.

- Standard tip clearance:
- 0.070 to 0.150 mm (0.0028 to 0.0059 in.)
- Maximum tip clearance:
- 0.150 mm (0.0059 in.)
- If the tip clearance is greater than the maximum, replace drive gear, the driven gear or pump body.
Using a steel straightedge and feeler gauge, measure the side clearance of both gears.

- Standard side clearance:
- 0.02 to 0.05 mm (0.0008 to 0.002 in.)
- Maximum side clearance:
- 0.05 mm (0.002 in.)
There are 5 different thicknesses for the drive and driven gears.
- Drive and drive gears thickness:
Mark
Thickness
0
10.74 to 10.749 mm (0.4228 to 0.4232 in.)
1
10.75 to 10.759 mm (0.4232 to 0.4236 in.)
2
10.76 to 10.77 mm (0.4236 to 0.424 in.)
3
10.771 to 10.78 mm (0.4241 to 0.4244 in.)
4
10.781 to 10.79 mm (0.4244 to 0.4248 in.)
- If the side clearance is greater than the maximum, replace drive gear, driven gear or pump body.
| INSPECT FRONT OIL PUMP DRIVE GEAR ROTATION |
![]() ![]() |
Make sure the drive gear rotates smoothly.
Remove the oil pump assembly from the torque converter.




