2014 Hilux · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT TRANSMISSION WIRE

C110342E96
  1. Measure the resistance according to the value(s) in the table below.

    HINT:
    If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.

    Standard Resistance:
    Tester Connection
    ATF Temperature
    Specified Condition
    2 (OT-) - 10 (OT+)
    20°C (68°F)
    5 to 8 kΩ
    2 (OT-) - 10 (OT+)
    25°C (77°F)
    2.5 to 4.5 kΩ
    2 (OT-) - 10 (OT+)
    110°C (230°F)
    0.22 to 0.28 kΩ
    1 (OT2-) - 9 (OT2+)
    20°C (68°F)
    5 to 8 kΩ
    1 (OT2-) - 9 (OT2+)
    25°C (77°F)
    2.5 to 4.5 kΩ
    1 (OT2-) - 9 (OT2+)
    110°C (230°F)
    0.22 to 0.28 kΩ

    If the result is not as specified, replace the transmission wire.

← REMOVAL (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →