P0756 Shift Solenoid "B" Performance (Shift Solenoid Valve S2)
Diagnostic trouble codes · Vehicles built from Jun 2011
DESCRIPTION
The ECM uses signals from the speed sensor (NC0) and speed sensor (SP2) to detect the actual gear position (1st, 2nd, 3rd or 4th gear).Then the ECM compares the actual gear position with the shift schedule in the ECM memory to detect mechanical problems of the shift solenoid valves, valve body or automatic transmission (clutch, brake or gear etc.).
| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0756 |
Gear required by ECM does not match actual gear when driving (2 trip detection logic) |
|
MONITOR DESCRIPTION
The ECM commands gear shifts by turning the shift solenoid valves "on/off". According to the input shaft revolution, intermediate (counter) shaft revolution and output shaft revolution, the ECM detects the actual gear position (1st, 2nd, 3rd or 4th gear). When the gear position commanded by the ECM and the actual gear position are not the same, the ECM illuminates the MIL and stores the DTC.INSPECTION PROCEDURE
| 1. CHECK DTC OUTPUT (IN ADDITION TO DTC P0756) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and push the intelligent tester main switch on.
Enter the following menus: Powertrain / ECT / DTC / Current or Pending.
Read the DTCs using the intelligent tester.
- Result:
Display (DTC output)
Proceed to
Only P0756 is output
A
P0756 and other DTCs are output
B
- HINT:
- If any other codes besides P0756 are output, perform troubleshooting for those DTCs first.
|
|
||||
| A | |
| 2. INSPECT SHIFT SOLENOID VALVE S2 |
Remove the shift solenoid valve S2.

Measure the resistance of the solenoid value.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
Shift solenoid S2 connector - Shift solenoid S2 body
20°C (68°F)
11 to 15 Ω
Connect the battery's positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.
Check the operating noise of the solenoid valve.
- OK:
- Solenoid makes operating noise.
|
|
||||
| OK | |
| 3. INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly.
- OK:
- There are no foreign objects on any valve.
|
|
||||
| OK | ||
| ||
