2014 Hilux · Service Manual TRANSMISSION

P0751 Shift Solenoid "A" Performance (Shift Solenoid Valve S1)

Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2013

DESCRIPTION

The TCM uses signals from the vehicle speed sensor and direct clutch speed sensor to detect the actual gear position (1st, 2nd, 3rd or 4th gear).
Then the TCM compares the actual gear with the shift schedule in the TCM memory to detect mechanical problems of the shift solenoid valves, valve body or automatic transmission (clutch, brake or gear, etc.).
DTC No.
DTC Detection Condition
Trouble Area
P0751
The gear required by the TCM does not match the actual gear when driving (2-trip detection logic)
  1. Shift solenoid valve S1 remains open or closed
  2. Valve body is blocked
  3. Automatic transmission (clutch, brake or gear, etc.)

MONITOR DESCRIPTION

This DTC indicates "stuck ON malfunction" or "stuck OFF malfunction" of the shift solenoid valve S1.
The TCM commands gear shifts by turning the shift solenoid valves "ON/OFF". When the gear position commanded by the TCM and the actual gear position are not the same, the TCM illuminates the MIL and stores the DTC.

INSPECTION PROCEDURE


1. CHECK DTC OUTPUT (IN ADDITION TO DTC P0751)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and push the intelligent tester main switch ON.

  1. Enter the following menus: Powertrain / ECT / DTC / Current or Pending.

  1. Read the DTCs using the intelligent tester.

    Result:
    Display (DTC output)
    Proceed to
    Only P0751 is output
    A
    P0751 and other DTCs are output
    B

    HINT:
    If any other codes besides P0751 are output, perform troubleshooting for those DTCs first.



B
GO TO DTC CHART
A


2. INSPECT SHIFT SOLENOID VALVE S1

  1. C157228E01
    Remove the shift solenoid valve S1.

  1. Measure the resistance of the solenoid value.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Shift solenoid S1 connector - Shift solenoid S1 body
    20°C (68°F)
    11 to 15 Ω

  1. Connect the battery's positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.

  1. Check the operating noise of the solenoid valve.

    OK:
    Solenoid makes operating noise.



NG
REPLACE SHIFT SOLENOID VALVE S1
OK


3. INSPECT TRANSMISSION VALVE BODY ASSEMBLY
  1. Check the transmission valve body assembly.

    OK:
    There are no foreign objects on each valve.



NG
REPAIR OR REPLACE TRANSMISSION VALVE BODY ASSEMBLY
OK

REPAIR OR REPLACE AUTOMATIC TRANSMISSION ASSEMBLY


← P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) (Jun 2011 – Jul 2013)P0756 Shift Solenoid "B" Performance (Shift Solenoid Valve S2) (Jun 2011 – Jul 2013) →