2014 Hilux · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT PACK CLEARANCE OF DIRECT CLUTCH

AT08250E01
  1. Place the direct clutch assembly onto the O/D support assembly.

  1. G037156E02
    Using SST and a dial indicator, measure the direct clutch pack clearance while applying and releasing compressed air (186 to 206 kPa (1.9 to 2.1 kgf/cm2, 27 to 30 psi)).
    SST
    09350-30020   (09350-06120)

    Pack clearance:
    0.40 to 0.70 mm (0.016 to 0.028 in.)

    If the pack clearance is not as specified, parts may have been assembled incorrectly. Check and reassemble again.
    If the pack clearance is still not as specified, select another flange.

    HINT:
    There are 8 different flange thicknesses.

    Standard flange thickness:
    No.
    Specified Condition
    No.
    Specified Condition
    53
    3.3 mm (0.130 in.)
    57
    3.7 mm (0.146 in.)
    54
    3.4 mm (0.134 in.)
    58
    3.8 mm (0.150 in.)
    55
    3.5 mm (0.138 in.)
    60
    4.0 mm (0.157 in.)
    56
    3.6 mm (0.142 in.)
    62
    4.2 mm (0.165 in.)


INSPECT DIRECT CLUTCH FLANGE

AT06454E03
  1. Replace all discs if one of the following problems is present: 1) a disc, plate or flange is worn or burnt, 2) the lining of a disc is peeled off or discolored, or 3) grooves or printed numbers have even a little bit of damage.

    NOTICE:
    Before assembling new discs, soak them in ATF for at least 15 minutes.


INSPECT DIRECT CLUTCH RETURN SPRING

D001246E02
  1. Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    21.32 mm (0.839 in.)

    If the length is not as specified, replace the spring.


INSPECT DIRECT CLUTCH PISTON

D001424E01
  1. Check that the check ball is free by shaking the piston.

  1. Check that the valve does not have leaks by applying low-pressure compressed air.


INSPECT DIRECT CLUTCH DRUM

D001352E01
  1. Using a dial indicator, measure the inside diameter of the clutch drum bush.

    Maximum inside diameter:
    53.97 mm (2.1248 in.)

    If the inside diameter is greater than the maximum, replace the clutch drum.

← DISASSEMBLY (from Jun 2011)REASSEMBLY (from Jun 2011) →