2014 Hilux · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL DIRECT CLUTCH PISTON

D001453E01
  1. Coat 2 new O-rings with ATF, and install them in the direct clutch piston.

  1. D001354E01
    Be careful not to damage the O-rings, and press in the direct clutch piston into the clutch drum with both hands.


2. INSTALL DIRECT CLUTCH RETURN SPRING

D001349E01

  1. D001348E01
    Place SST on the spring retainer, and compress the return spring with a press.
    SST
    09350-30020   (09350-07040)

  1. Using SST, install the snap ring.

    SST
    09350-30020   (09350-07070)

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the spring retainer claw.


3. INSTALL DIRECT CLUTCH FLANGE

AT01640E01
  1. Install the cushion plate.

  1. Install the 4 plates and 4 discs.

    Install in order:
    P - D - P - D - P - D - P - D

    HINT:
    P = Plate
    D = Disc

  1. Install the flange with the flat end facing downward.

  1. G037155E01
    Using a screwdriver, install the snap ring.

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the cutout portion of the direct clutch drum.


4. INSPECT PACK CLEARANCE OF DIRECT CLUTCH

AT08250E01
  1. Place the direct clutch assembly onto the O/D support assembly.

  1. G037156E01
    Using SST and a dial indicator, measure the direct clutch pack clearance while applying and releasing compressed air (186 to 206 kPa (1.9 to 2.1 kgf/cm2, 27 to 30 psi)).
    SST
    09350-30020   (09350-06120)

    Pack clearance:
    0.40 to 0.70 mm (0.016 to 0.028 in.)

    If the pack clearance is not as specified, parts may have been assembled incorrectly. Check and reassemble again.

    HINT:
    1. If the pack clearance is still not as specified, select another flange.
    2. There are 8 different flange thicknesses.

    Standard flange thickness:
    No.
    Specified Condition
    No.
    Specified Condition
    53
    3.3 mm (0.130 in.)
    57
    3.7 mm (0.146 in.)
    54
    3.4 mm (0.134 in.)
    58
    3.8 mm (0.150 in.)
    55
    3.5 mm (0.138 in.)
    60
    4.0 mm (0.157 in.)
    56
    3.6 mm (0.142 in.)
    62
    4.2 mm (0.165 in.)

← INSPECTION (from Jun 2011)COMPONENTS (from Jun 2011) →