P2716/77 Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT)
Diagnostic trouble codes · Vehicles built from Jun 2011
DESCRIPTION


The throttle pressure that is applied to the primary regulator valve (which modulates the line pressure) causes the solenoid valve SLT, under electronic control, to precisely modulate and generate the line pressure according to the extent that the accelerator pedal is depressed or the output of engine power.
This controls the line pressure and provides smooth shifting characteristics.
Upon receiving a signal of the throttle valve opening angle, the TCM controls the line pressure by sending a predetermined duty ratio* to the solenoid valve, modulating the line pressure and generating throttle pressure.
- HINT:
-


- *: The duty ratio is the ratio of the current ON time (A) to the total of the current ON and OFF time (A + B).
- Duty Ratio (%) = A / (A + B) x 100
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P2716/77 |
TCM detects shift solenoid valve SLT circuit malfunction for 1 sec. or more (1 trip detection logic) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SLT) |
Disconnect the E1 wire connector.

Measure the resistance of the transmission wire.
- Standard resistance:
Tester Connection
Condition
Specified Condition
2 (SLT+) - 6 (SLT-)
20°C (68°F)
5.0 to 5.6 Ω
2 (SLT+) - Body ground
20°C (68°F)
10 kΩ or higher
6 (SLT-) - Body ground
20°C (68°F)
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (SHIFT SOLENOID VALVE SLT - TCM) |
Disconnect the T19 TCM connector.

Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Condition
Specified Condition
T19-20 (SLT+) - T19-19 (SLT-)
20°C (68°F)
5.0 to 5.6 Ω
T19-20 (SLT+) - Body ground
20°C (68°F)
10 kΩ or higher
T19-19 (SLT-) - Body ground
20°C (68°F)
10 kΩ or higher
|
|
||||
| OK | ||
| ||
| 3. INSPECT SHIFT SOLENOID VALVE SLT |
![]() ![]() |
Remove the shift solenoid valve SLT.
Measure the resistance between the solenoid valve terminal and solenoid valve body.
- Standard resistance:
- 5.0 to 5.6 Ωat 20°C (68°F)
Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.
Check the operating noise of terminal 1 of the solenoid valve.
- OK:
- Solenoid makes operating noise.
- HINT:
-


- Reference: Inspection using an oscilloscope.
- Check the waveform of the TCM connector.
- OK:
- Refer to illustration
Item
Content
Tester Connection
T19-20 (SLT+) - T19-19 (SLT-)
Tool Setting
5 V/DIV., 1 msec./DIV.
Condition
Engine idle speed
|
|
||||
| OK | ||
| ||

