INSTALLATION
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. INSTALL STARTER ASSEMBLY |
Install the starter with the 2 bolts.

- Torque:
- 58 N*m{ 591 kgf*cm , 43 ft.*lbf }
Connect the starter wire with the nut

- Torque:
- 9.8 N*m{ 100 kgf*cm , 87 in.*lbf }
Connect the terminal cap.
Connect the starter connector.
Connect the ground wire with the bolt
- Torque:
- 20 N*m{ 202 kgf*cm , 15 ft.*lbf }
| 2. INSTALL FRONT FENDER SEAL |
Install the seal with the 5 clips.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
