2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


REMOVE STARTER RELAY (Marking: ST)
  1. Remove the engine room relay block cover.

  1. Remove the starter relay from the engine room relay block.


INSPECT STARTER RELAY

  1. A111813E01
    Measure the resistance of the starter relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.


INSTALL STARTER RELAY

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

← ON-VEHICLE INSPECTION (Aug 2012 – Jul 2013)ON-VEHICLE INSPECTION (Jun 2011 – Jul 2012) →