2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE ENGINE COVER SUB-ASSEMBLY

  1. A110362
    Remove the 3 bolts, 2 nuts and cover.


3. REMOVE CHARGE AIR COOLER ASSEMBLY

  1. A110365
    Disconnect the diesel turbo IAT sensor connector.

  1. Loosen the 2 hose clamps of the No. 1 air hose.

  1. A110366
    Loosen the 2 hose clamps of the No. 2 air hose.

  1. A110367
    Remove the 4 bolts and CAC.

  1. A112149
    Using a 22 mm deep socket wrench, remove the IAT sensor.

    HINT:
    Replace the IAT sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the IAT sensor each time the CAC is replaced.

  1. A112150
    Remove the 4 bolts, intake air connector and gasket.


4. REMOVE VACUUM SWITCHING VALVE BRACKET

  1. A110298
    Disconnect the 2 connectors.

  1. Disconnect the vacuum hoses from the 3 locations.

  1. Remove the 2 bolts and bracket.


5. REMOVE DIESEL THROTTLE BODY ASSEMBLY

  1. A111790
    Disconnect the 2 connectors.

  1. A111832
    Remove the 2 bolts, 2 nuts, throttle body and gasket.


6. REMOVE THROTTLE BODY BRACKET

  1. A110300
    Remove the 3 bolts and bracket.


7. REMOVE INTAKE AIR CONNECTOR
  1. Remove the 2 nuts, bolt, air connector and bracket.


8. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY

A099621E01
  1. Remove the 2 bolts, 2 nuts, pipe and 2 gaskets.


9. REMOVE EGR VALVE ASSEMBLY
  1. Remove the EGR valve and gasket.


10. REMOVE NO. 1 GLOW PLUG CONNECTOR
  1. Remove the nut and wire harness.

  1. Remove the 4 screw grommets, 4 nuts and glow plug connector.


11. REMOVE GLOW PLUG ASSEMBLY

A111830
  1. Using a 12 mm deep socket wrench, remove the 4 glow plugs.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →