REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.
| 2.
REMOVE NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY
|
 |
Disconnect the manifold absolute pressure sensor connector.
Disconnect the vacuum hose from the gas filter.
Loosen the 2 clamps.
Remove the bolt and disconnect the pipe together with the 2 air hoses.
| 3.
REMOVE VACUUM SWITCHING VALVE BRACKET |
 |
Remove the 2 bolts and bracket.
| 4.
REMOVE DIESEL THROTTLE BODY ASSEMBLY
|
 |
- Disconnect the 2 connectors.
- Remove the 2 bolts, 2 nuts, throttle body and gasket.
| 5.
REMOVE THROTTLE BODY BRACKET |
 |
Remove the 3 bolts and bracket.
| 6.
REMOVE INTAKE AIR CONNECTOR |
 |
Remove the 2 nuts, bolt, air connector and bracket.
| 7.
REMOVE NO. 1 GLOW PLUG CONNECTOR |
 |
Remove the nut and wire harness.
Remove the 4 screw grommets, 4 nuts and glow plug connector.
| 8.
REMOVE GLOW PLUG ASSEMBLY |
 |
Using a 12 mm deep socket wrench, remove the 4 glow plugs.