REMOVAL
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.
| 2. REMOVE NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY |
![]() ![]() |
Disconnect the manifold absolute pressure sensor connector.
Disconnect the vacuum hose from the gas filter.
Loosen the 2 clamps of the No. 1 and No. 2 air hoses.
Remove the bolt and cleaner pipe together with the 2 air hoses.
| 3. REMOVE VACUUM SWITCHING VALVE BRACKET |
![]() ![]() |
Remove the 2 connectors from the E-VRV and EGR valve.
Disconnect the vacuum hoses from the 2 locations.
Remove the 2 bolts and bracket.
| 4. REMOVE DIESEL THROTTLE BODY ASSEMBLY |
Disconnect the 2 connectors.

Remove the 2 bolts, 2 nuts, throttle body and gasket.

| 5. REMOVE THROTTLE BODY BRACKET |
Remove the 3 bolts and bracket.
| 6. REMOVE INTAKE AIR CONNECTOR |
Remove the 2 nuts, bolt, air connector and bracket.
| 7. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY |
| 8. REMOVE EGR VALVE ASSEMBLY |
Remove the EGR valve and gasket.
| 9. REMOVE NO. 1 GLOW PLUG CONNECTOR |
Remove the nut and wire harness.
Remove the 4 screw grommets, 4 nuts and glow plug connector.
| 10. REMOVE GLOW PLUG ASSEMBLY |
![]() ![]() |
Using a 12 mm deep socket wrench, remove the 4 glow plugs.



