ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT ILLUMINATION DURATION OF GLOW INDICATOR LIGHT |
Inspect the light illumination duration.


Text in Illustration *a
Light Illumination Duration
*b
Engine Coolant Temperature
Turn the ignition switch to ON, and then measure the light illumination duration.
- Light illumination duration:
- Refer to the graph.
Turn the ignition switch off.
- If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.
- HINT:
- Actual light illumination duration may vary slightly from the graph.
- If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.
| INSPECT PRE-HEATING |
Inspect the pre-heating time.

Text in Illustration *a
Pre-heating Time
*b
Battery Voltage
Turn the ignition switch to ON. Measure how long it takes for battery voltage to be applied to the glow plugs.
- Standard Time:
Engine Coolant Temperature
Pre-heating Time
40°C (104°F) or higher
1 second
below 40°C (104°F)
Refer to the graph
(maximum: 15 seconds)
Turn the ignition switch off.
- If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.
- If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.
Turn the ignition switch to START. Check that battery voltage is applied to the glow plugs.
While cranking the engine, measure how long it takes for battery voltage to be applied to the glow plugs.
- Standard Time:
Engine Coolant Temperature
Pre-heating Time
40°C (104°F) or higher
1 second
below 40°C (104°F)
Refer to the graph
(maximum: 15 seconds)
- If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.
| INSPECT AFTER GLOW TIME |
Inspect the afterglow time.


Text in Illustration *a
Component with harness connected (ECM)
*b
After Glow Time
*c
Engine Coolant Temperature
-
-
After the engine starts, measure how long it takes for battery voltage to be applied to terminals G39-15 (GREL) and C23-7 (E1) of the ECM.
- Standard Time:
Tester Connection
Specified Condition
G39- 15 (GREL) - C23-7 (E1)
Refer to the graph
- If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.
