2014 Hilux · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jun 2011


1. INSTALL NO. 2 ECM BRACKET
  1. Install the No. 2 ECM bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


2. INSTALL NO. 1 ECM BRACKET
  1. Install the No. 1 ECM bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


3. INSTALL ECM
  1. Install the ECM with the bolt and 2 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 6 connectors.


4. INSTALL 4WD CONTROL ECU (for 4WD)
  1. Install the 4WD control ECU with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.


5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
(Click here)

6. PERFORM REGISTRATION
  1. Perform registration (Click here).

    HINT:
    Only perform registration when the ECM is replaced, either by itself or in any of the following combinations.
    1. ECM and Fuel Supply Pump
    2. ECM and Diesel Throttle Body Assembly
    3. ECM and Injector Assembly
    4. ECM and Engine Assembly


7. START ENGINE
  1. When replacing the ECM, start the engine to initialize the new ECM (Click here).

← REMOVAL (from Jun 2011)COMPONENTS (from Jun 2011) →