2014 Hilux · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL NO. 2 ECM BRACKET

A122796E01
  1. Install the bracket with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


2. INSTALL NO. 1 ECM BRACKET

A122795E01
  1. Install the bracket with the 3 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


3. INSTALL ECM

A151316
  1. Install the ECM with the bolt and 2 nuts.

    Torque:
    12.5 N*m{ 128 kgf*cm , 9 ft.*lbf }

  1. Connect the 4 connectors.


4. INSTALL TRANSMISSION CONTROL ECU ASSEMBLY (for Automatic Transmission)

A151315
  1. Install the TCM with the 2 bolts.

    Torque:
    12.5 N*m{ 128 kgf*cm , 9 ft.*lbf }

  1. Connect the 3 connectors.


5. REMOVE TURBO MOTOR DRIVER

  1. A151314
    Install the turbo motor driver with the bolt.

    Torque:
    12.5 N*m{ 128 kgf*cm , 9 ft.*lbf }

  1. Connect the connector.


6. INSTALL 4WD CONTROL ECU (w/ A.D.D.)

A151313
  1. Install the 4WD control ECU with the bolt.

    Torque:
    12.5 N*m{ 128 kgf*cm , 9 ft.*lbf }

  1. Connect the connector.


7. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

B278068E01
  1. Attach the 2 hinges to install the glove compartment door.

    Text in Illustration 
    *1
    Hinge

  1. B278069E01
    While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.
    Text in Illustration 
    *1
    Stopper


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

9. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.


10. PERFORM REGISTRATION (w/ EGR Cooler)
  1. Perform registration (Click here).


11. PERFORM REGISTRATION (w/o EGR Cooler)
  1. Perform registration (Click here).


12. START ENGINE (w/ EGR Cooler)

NOTICE:
After replacing the ECM, the new ECM needs to be initialized (Click here).


13. START ENGINE (w/o EGR Cooler)

NOTICE:
After replacing the ECM, the new ECM needs to be initialized (Click here).

← INSTALLATION (Jun 2011 – Jul 2012)INSTALLATION (from Aug 2013) →