2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.

NOTICE:
When disconnecting the cable, systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

B278058E01
  1. Slightly bend the upper part of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.

    Text in Illustration 
    *1
    Stopper

  1. B278059E01
    Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.
    Text in Illustration 
    *1
    Hinge


3. REMOVE 4WD CONTROL ECU (for 4WD)

  1. A211934E02
    Disconnect the connector.

  1. Remove the bolt and 4WD control ECU.


4. REMOVE TURBO MOTOR DRIVER (for Motor Controlled Actuator)

  1. A191420E03
    Disconnect the connector.

  1. Remove the bolt and turbo motor driver.


5. REMOVE ECM

  1. A191421E03
    Disconnect the 4 connectors.

  1. Remove the bolt, 2 nuts and ECM.


6. REMOVE NO. 1 ECM BRACKET

  1. A191416
    for LHD:
    Remove the 3 screws and bracket.

  1. A224463
    for RHD:
    Remove the 3 screws and bracket.


7. REMOVE NO. 2 ECM BRACKET

  1. A191417
    for LHD:
    Remove the 2 screws and bracket.

  1. A224464
    for RHD:
    Remove the 2 screws and bracket.

← COMPONENTS (from Aug 2012)REMOVAL (Aug 2012 – Jul 2013) →