INSTALLATION
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. INSTALL CRANK SHAFT POSITION SENSOR |
Apply a light coat of engine oil to the O-ring of the sensor.
Install the sensor with the bolt.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }


Install the 3 clips and connect the sensor connector.
- NOTICE:
- Insert the crankshaft position sensor wire harness into the protrusions of the timing gear cover as shown in the illustration.
| 2. INSTALL NO. 2 ENGINE UNDER COVER |
| 3. INSTALL NO. 1 ENGINE UNDER COVER |
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. PERFORM INITIALIZATION |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
