REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DRAIN ENGINE COOLANT |
- NOTICE:
- Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

Loosen the cylinder block drain cock plug and the radiator drain cock plug.
- HINT:
- Collect the coolant in a container and dispose of it according to the regulations in your area.


| 3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR |
Disconnect the sensor connector.

Remove the sensor.
Remove the gasket from the sensor.
