REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() ![]() |
Remove the 3 bolts, 2 nuts and engine cover.
| 3. REMOVE CHARGE AIR COOLER ASSEMBLY WITH INTAKE AIR CONNECTOR |
Disconnect the vacuum hose from the manifold absolute pressure sensor.

Disconnect the IAT sensor connector and manifold absolute diesel pressure sensor connector.
Loosen the 2 hose clamps of the No. 1 air hose.

Loosen the 2 hose clamps of the No. 2 air hose.

Remove the 4 bolts and CAC.

| 4. REMOVE DIESEL THROTTLE BODY ASSEMBLY |
Disconnect the 2 connectors.

Remove the 2 bolts, 2 nuts, throttle body and gasket.


