INSTALLATION
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. INSTALL ACCELERATOR PEDAL ROD ASSEMBLY |
![]() ![]() |
- NOTICE:
- Avoid excessive force to the accelerator pedal sensor.
- Do not disassemble the accelerator pedal sensor assembly.
- This accelerator pedal does not require lubrication.
Do not apply oil or lubricant to the accelerator pedal sensor assembly.
If applied, the accelerator pedal rod assembly must be replaced.
- Avoid excessive force to the accelerator pedal sensor.
Install the pedal rod with the 2 bolts.
- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
Connect the accelerator position sensor connector.
| 2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 3. PERFORM INITIALIZATION |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.


