2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE ACCELERATOR PEDAL ROD ASSEMBLY

A098860E01

NOTICE:
  1. Avoid excessive force to the accelerator pedal sensor.
  2. Do not disassemble the accelerator pedal sensor assembly.
  3. This accelerator pedal does not require lubrication.
    Do not apply oil or lubricant to the accelerator pedal sensor assembly.
    If applied, the accelerator pedal rod assembly must be replaced.

  1. Disconnect the accelerator position sensor connector.

  1. Remove the 2 bolts and pedal rod.

← ON-VEHICLE INSPECTION (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →