INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT NO. 1 VACUUM SWITCHING VALVE (for EGR Cut) |
Measure the resistance of the VSV.

- Standard resistance:
Tester Connection
Specified Condition
1 - 2
37 to 44 Ω at 20°C (68°F)
1 - Body Ground
2 - Body Ground
1 MΩ or higher
Check operation of the VSV.

Attach a vacuum pump to port E, and check that vacuum does not flow from the filter to port E.
If the result is not as specified, replace the vacuum switching valve.
Apply battery voltage across terminals 1 and 2.

Attach a vacuum pump to port E, and check that vacuum flows from the filter to port E.
If the result is not as specified, replace the vacuum switching valve.
| INSPECT NO. 2 VACUUM SWITCHING VALVE (for No. 2 EGR) |
Measure the resistance of the VSV.

- Standard resistance:
Tester Connection
Specified Condition
1 - 2
37 to 44 Ω at 20°C (68°F)
1 - Body Ground
2 - Body Ground
1 MΩ or higher
Check operation of the VSV.

Attach a vacuum pump to port E, and check that vacuum flows from the filter to port E.
If the result is not as specified, replace the vacuum switching valve.
Apply battery voltage across terminals 1 and 2.

Attach a vacuum pump to port E, and check that vacuum flows from port E to port F.
If the result is not as specified, replace the vacuum switching valve.
