2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT INTAKE MANIFOLD

NOTICE:
A110307E01
Do not adjust the adjusting screw.

  1. A099627E01
    Disconnect the vacuum hose from the actuator.

  1. Check the operation of the swirl control valve.

    1. Check that the valve is fully opened under normal conditions.

    2. Connect a vacuum pump to the control valve. Check that the valve is fully closed when a negative pressure of 35 kPa (270 mmHg, 10 in.Hg) is applied.

    3. Wait for 1 minute and check that the vacuum pump needle does not move.
      If the result is not as specified, replace the intake manifold.


INSPECT VACUUM SWITCHING VALVE (for Swirl Control Valve)

  1. A110308E06
    Measure the resistance of the VSV.

    Standard Resistance:
    Tester Connection
    Specified Condition
    1 - 2
    33 to 39 Ω at 20°C (68°F)
    1 - Body ground
    2 - Body ground
    10 kΩ or higher

    If the result is not as specified, replace the intake manifold assembly.

  1. G037162E01
    Check the operation of the VSV.

    1. Check that air flows from port E to the filter.
      If the result is not as specified, replace the intake manifold assembly.

    2. A110309E01
      Apply battery voltage across the terminals.

    3. Check that air flows from port E to port F.
      If the result is not as specified, replace the intake manifold assembly.

← REMOVAL (from Aug 2013)INSTALLATION (Jun 2011 – Jul 2012) →