2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT FOR COOLANT LEAK

NOTICE:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. A097645E01
    Fill the radiator with coolant and attach a radiator cap tester to the radiator reservoir.

  1. Warm up the engine.

  1. Using the radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2 ,17.1 psi), and check that the pressure does not drop.
    If the pressure drops, check the hoses, radiator and water pump for leaks.
    If no external leaks are found, check the cylinder block and head.


CHECK ENGINE COOLANT LEVEL IN RESERVOIR

  1. A151118
    The engine coolant level should be between the L and F lines when the engine is cold.
    If low, check for leaks and add TOYOTA Super Long Life Coolant (SLLC) or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology up to the F line.

    NOTICE:
    Never use water as a substitute for engine coolant.


CHECK ENGINE COOLANT QUALITY
  1. Remove the radiator reservoir cap.

    NOTICE:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Check if there are excessive deposits of rust or scales around the radiator reservoir cap and radiator filler hole. Also, the coolant should be free of oil.
    If excessively dirty, replace the coolant.

  1. Install the radiator reservoir cap.

← INSTALLATION (from Aug 2013)ON-VEHICLE INSPECTION (from Jun 2011) →