2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 4 bolts and cover.


3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. A099591E01
    Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

  1. Loosen the cylinder block drain cock plug.

    A147246E01


4. REMOVE AIR CLEANER ASSEMBLY

A099628E02
  1. Disconnect the MAF meter connector and remove the clamp.

  1. Loosen the hose clamp of the compressor inlet elbow.

  1. for Ventilation Hose Type:
    Disconnect the ventilation hose.

  1. Remove the 2 bolts and air cleaner.


5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

  1. A110362
    Remove the 3 bolts, 2 nuts and cover.


6. REMOVE INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR

  1. A149802
    Detach the 2 clamps.

  1. Disconnect the vacuum hose from the manifold absolute pressure sensor.

  1. Disconnect the IAT sensor connector and manifold absolute diesel pressure sensor connector.

  1. A149933
    Loosen the 2 hose clamps of the No. 1 air hose.

  1. A149934
    Loosen the 2 hose clamps of the No. 2 air hose.

  1. A135919
    Remove the 4 bolts and intercooler.


7. REMOVE COMPRESSOR INLET ELBOW

  1. A110341
    for Ventilation Pipe Type:
    Remove the ventilation pipe.

    1. Move the clamp so that the hose can be disconnected.

    2. Remove the ventilation pipe.

  1. Disconnect the 2 connectors from the turbocharger.

  1. Remove the wire clamp's clip from the inlet elbow.

  1. Remove the 2 nuts, inlet elbow and gasket.


8. DISCONNECT RADIATOR HOSE INLET

9. DISCONNECT NO. 1 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP (for Automatic Transmission)

A097634E01
  1. Remove the bolt and disconnect the clamp.


10. REMOVE WATER INLET

A097637E01
  1. Remove the 3 bolts and water inlet.


11. REMOVE THERMOSTAT
← COMPONENTS (from Aug 2012)REMOVAL (from Aug 2012) →