2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.


2. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD)
  1. Remove the 4 bolts and No. 1 engine under cover.


3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. A099591E01
    Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.

  1. Loosen the cylinder block drain cock plug.

    A147246E01


4. REMOVE RADIATOR GRILLE

  1. B277710E01
    Put protective tape around the radiator grille.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 clips and 2 screws.

  1. B277711
    Detach the 6 claws and remove the radiator grille.


5. REMOVE RADIATOR SIDE DEFLECTOR LH

  1. A110374
    Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.


6. REMOVE RADIATOR SIDE DEFLECTOR RH
  1. Using a clip remover, remove the 2 clips.

  1. Detach the claw and remove the deflector.


7. DISCONNECT RADIATOR HOSE INLET

8. DISCONNECT RADIATOR HOSE OUTLET

9. REMOVE FAN SHROUD

A151122
  1. Remove the 3 bolts and oil reservoir.

  1. Disconnect the No. 1 and No. 2 water by-pass hoses from the tank upper and lower.

  1. Remove the 2 bolts and radiator reservoir.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the drive belt (Click here).

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.


10. REMOVE RADIATOR ASSEMBLY

A097639E01
  1. Remove the 4 bolts and radiator.

← ON-VEHICLE CLEANING (from Jun 2011)DISASSEMBLY (from Jun 2011) →