INSTALLATION
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL OIL FILTER SUB-ASSEMBLY |
Check and clean the oil filter installation surface.
Apply clean engine oil to the gasket of a new oil filter.
Install the oil filter, and tighten it by hand until the gasket contacts the installation surface.
Using SST, tighten it by an additional 3/4 turn to seat the filter.

- SST
- 09228-44011
| 2. ADD ENGINE OIL |
Add fresh engine oil.
- Standard capacity:
Item
Specified Condition
Drain and refill with oil filter change
7.2 liters (7.6 US qts, 6.3 Imp. qts)
Drain and refill without oil filter change
6.7 liters (7.1 US qts, 5.9 Imp. qts)
Dry fill
8.4 liters (8.9 US qts, 7.4 Imp. qts)
Reinstall the oil filler cap.
| 3. CHECK FOR ENGINE OIL LEAKS |
