REASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL TIGHT PLUG |
![]() ![]() |
Apply adhesive to a new tight plug.
- Adhesive:
- Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Using SST and a hammer, tap in the tight plug as shown in the illustration.
Position A- SST
- 09950-60010
(09951-00200)
09950-70010 (09951-07100)
- SST
- 09950-60010
(09951-00300)
09950-70010 (09951-07100)
- SST
- 09950-60010
(09951-00350)
09950-70010 (09951-07100)


| 2. INSTALL STUD BOLT |


- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf } for A and F
- 7.0 N*m{ 71 kgf*cm , 62 in.*lbf } for B
- 15 N*m{ 153 kgf*cm , 11 ft.*lbf } for C
- 26 N*m{ 265 kgf*cm , 19 ft.*lbf } for D and E
| 3. INSTALL RING PIN |


| 4. INSTALL STRAIGHT SCREW PLUG |
Apply an adhesive to the end of the screw plug.
- Adhesive:
- Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Using a 6 mm hexagon wrench, install the screw plug.
- Torque:
- 25 N*m{ 255 kgf*cm , 18 ft.*lbf }


| 5. INSTALL SEMICIRCULAR PLUG |
Remove any old packing (FIPG) material.
Apply seal packing to the oil seal retainer as shown in the illustration.
- Seal packing:
- Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
- NOTICE:
- The semicircular plug must be installed within 3 minute from the completion of applying the seal packing.
- Prevent FIPG from being stuck to the camshaft thrust groove.
- The semicircular plug must be installed within 3 minute from the completion of applying the seal packing.
Install the semicircular plug to the cylinder head.


| 6. INSTALL INTAKE VALVE |
![]() ![]() |
Install the valve, spring seat, compression spring and spring retainer.
Using SST, compress the compression spring and place the 2 valve spring retainer locks around the valve stem.
- SST
- 09202-70020
(09202-00020)
Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.

- NOTICE:
- Be careful not do damage the valve stem tip.
| 7. INSTALL EXHAUST VALVE |
![]() ![]() |
Install the valve, spring seat, compression spring and spring retainer.
Using SST, compress the compression spring and place the 2 valve spring retainer locks around the valve stem.
- SST
- 09202-70020
(09202-00020)
Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.

- NOTICE:
- Be careful not to damage the valve stem tip.
| 8. INSTALL VALVE LIFTER |
Install the valve lifter.
Check that the valve lifter rotates smoothly by hand.



