2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


CHECK ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick's low and full level marks.
    If the oil level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill engine oil above the full level mark.


CHECK ENGINE OIL QUALITY

  1. Check the oil for deterioration, water contamination, discoloring or thinning.
    If the quality is visibly poor, replace the oil.

    HINT:
    1. TOYOTA Genuine Motor Oil is in this vehicle when it is shipped.
    2. Use TOYOTA Genuine Motor Oil or equivalent to satisfy the following grade and viscosity.

    Oil grade:
    G-DLD1, API CF-4, CF or ACEA B1 (You may also use API CE or CD)

    If using SAE 10W-30 or a higher viscosity engine oil in extremely low temperatures, the engine may become difficult to start. For low temperatures SAE 5W-30 engine oil is recommended.

    A260999E01


CHECK OIL PRESSURE
  1. Disconnect the oil pressure switch connector.

  1. Using a 24 mm deep socket wrench, remove the oil pressure switch.

  1. B011501E01
    Install the oil pressure gauge.

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard oil pressure:
    Condition
    Specified Condition
    Idle
    29 kPa (0.3 kgf/cm2, 4.2 psi) or more
    3,000 rpm
    245 kPa (2.5 kgf/cm2, 36 psi) or more

    If the oil pressure is not as specified, check the oil pump.

  1. Remove the oil pressure gauge.


INSTALL OIL PRESSURE SWITCH ASSEMBLY

P013638E01
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 152 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation of the switch.

  1. Connect the oil pressure switch connector.

  1. Start the engine and check for engine oil leaks.

← ON-VEHICLE INSPECTION (from Jun 2011)COMPONENTS (from Jun 2011) →